RENCEL Climate Science Toolkit | Oceans, Ice, and Rocks
Long before the age of sophisticated instrumentation or satellite gps systems, explorers discovered one of the most important characteristics of the oceans, the great currents that traverse them and move enormous volumes of water from one part of the planet to another. One of the best known in America and Europe is the Gulf Stream, named by and explored with only thermometers by Benjamin Franklin. The current, shown in this map, moves north along the coast of North America and then east toward northern Europe. Its discovery is often credited to Ponce de Leon. The current is so strong that sailing ships trying to sail against it (from east to west) sometimes actually traveled backwards when the winds were weak. Trips westward from Europe to North America could take two weeks longer than the eastward journey, if the navigators sailed in (against) the current instead of outside it.
Due to his position with the American post office (in England) this latter observation was brought to Franklin’s attention in about 1769. He consulted a Nantucket merchant captain, Timothy Folger, who informed him about the current that was well known to colonial sailors. Franklin and Folger published this map, first in England and later in France, as an aid to sea traffic, including speedier mail delivery. Franklin followed up with experiments on his several trans-Atlantic voyages during which he measured the temperature of the ocean within and beside the current, finding that the temperature of the current was several degrees warmer than its boundary waters.
His findings led him to suggest an origin for the current, to give it the name “Gulph Stream,” and, always the practical scientist, thermal energyto suggest that navigators add thermometers to their other instruments so as to take advantage of the current when eastbound and avoid it westbound. In essence, expansion of tropical waters by solar heating and the prevailing winds cause the western part of the ocean to be “heaped up” and steered clockwise around the north Atlantic basin by the Coriolis effect as the heap “falls” toward the lower water level to the north.
In addition to ships, the warm Gulf Stream conveys large amounts of thermal energy from the tropics to northern latitudes. The relatively mild winter climate of the British Isles and year-round ice-free harbors in Norway are among the consequences of this transfer of energy. The Gulf Stream and its complementary return current comprise one of the five major oceanic gyres, large systems of rotating ocean currents shown in the figure below. The gyres in the north and south Atlantic and Pacific and Indian oceans transfer energy rapidly, on a time scale of months, from low to high latitudes and tend to even out the temperature across the globe. Because they are wind-driven, the gyres are not very deep. Only about 100 meters or so of the ocean surface moves in the gyre, but this is a great deal of water. The water flow of the north Atlantic gyre, for example, is larger than the total flow of all the Earth’s rivers.
The fast-moving gyres do not mix much water between ocean basins. But a deep, slow-moving ocean current does mix water from all the ocean basins. It takes 1000-2000 years to complete the circuit shown in the figure below. When warm, salty surface waters get far enough north or south toward the poles, winds cool the surface, evaporate the water, and initiate freezing. Since it is pure water that evaporates or freezes out, the cold liquid that remains is increased in salinity and density. The dense saline solution sinks into the less dense liquid below and flows along the bottom toward the warmer less dense ocean at the equator.
thermal energyThe driving force for this “ocean conveyor belt” is the increased density caused by cooling and increased salinity, so the circulation is sometimes labeled as “thermohaline”, combining “thermo” (heat effect) and “haline” (salt effect). In climate science literature, it is usually called the meridional overturning circulation, or simply MOC, because it exchanges (overturns) deep and surface waters from north to south (meridionally). All branches of the MOC are connected through the parts of the current that circle Antarctica.
What goes down must come up. As cold, dense saline water sinks at high latitudes, it pushes deep water toward the surface at lower latitudes, as you can see toward the middle of the figure. This upwelling of the deep ocean water is essential to life in the oceans. From the ocean floor, these waters carry to the surface dissolved CO2 and minerals required by the microscopic,, photosynthetic phytoplankton that inhabit the top sunlit layer of the ocean. These organisms are the base of the food web that feeds essentially all marine life. About half of all photosynthesis on Earth is carried out by the phytoplankton, so their carbon-fixing and oxygen release contributions are significant. The nutrient-carrying capacity of the thermohaline-driven MOC is an important adjunct to its energy transfer properties.
thermal energyAll of the above phenomena have been part of Earth’s climate story for millennia. The other modules in this ACS Climate Science Toolkit focus on how outward radiative transfer of thermal IR radiation via greenhouse gases has maintained Earth’s energy balance at a temperature supporting abundant life on land and sea. Now, as a result of added atmospheric greenhouse gases, the energy balance has been upset. The planet is absorbing more energy than is leaving, so it is warming. The average temperature at the surface has warmed by about 0.6 K since 1950. The extra energy cannot have all remained at the surface or only warmed the atmosphere—the subsurface ocean must also have gained thermal energy. The data in this figure are derived from the temperature, salinity, and density of the ocean as a function of depth. The density and salinity are used to determine the heat capacity of the seawater at each depth, so that the temperature values can be converted to energy units. The instrumentation used to obtain these data is briefly described and pictured in the sidebar. The figure shows the energy content in the top 2000 meters of the ocean and the fraction that is found below 700 meters.
The figure shows that the ocean’s thermal energy gain over the 55-year period of measurements is about 24 × 1022 J in the 0-2000 m layer. About 30% of this, 7 × 1022 J, is in the lower 700-2000 m part, which indicates that a significant part of the energy gets mixed from the surface to moderately deep waters. Data for deeper abyssal waters are sparse, but suggest that they have gained only a few percent as much as the upper layers. As we have seen above, the deep water current is very slow, so not a large amount of the warmed upper layers has yet reached the bottom.
thermal energyThe warming of the upper layers of the ocean from 1955 to 2010 has been about 0.09 °C, averaged over the entire 0-2000 m layer, and about 0.18 °C, averaged over just the upper, warmer 0-700 m layer. As the oceans warm their volume expands. Since their area is constrained within the continental walls, expansion increases sea level. This thermosteric effect has averaged a little over 0.5 mm•yr–1 for the 1955-2010 period—about 3 cm during this time. In addition, melting of glaciers, snow cover, and land ice sheets has added to sea level rise for a total of about 10 cm during this period.
This graphic helps to put the warming ocean’s role in climate science in perspective.
As one of the world’s leading district heating consultancies, RENCEL has more than decade of experience from projects in more than 25 countries. Our services encompass all stages of planning, design, operation, maintenance and management, including technical, institutional, legal, as well as economic aspects. In recent years we have also actively engaged ourselves in several district cooling projects. As cities aim to be carbon neutral, district heating and cooling systems become more important than ever. Our international market for these services is growing, not least due to a growing concern with climate change.
Hot water district heating
A city-wide, low-temperature hot water district heating system is key to any low-carbon city. The system is cost-effective and uses efficient, carbon neutral heat sources that would otherwise be wasted.
The heat sources derive from CHP plants with heat accumulators, waste-to-energy plants, geothermal plants, biomass boilers, large-scale heat pumps and large-scale solar heating plants.
Even for small settlements, district heating with thermal storage can be the key component of the most intelligent, cost-effective and carbon neutral heating for both existing and new buildings.
District heating steam and super-heated water
A special system for district heating, based on super-heated water or steam, is used mainly for industrial processes, but also in some cities and hospitals. RENCEL has extensive experience with these systems, including the design of pipe systems with a proven lifetime of more than 50 years. We also have experience in transforming these systems into more efficient, low-temperature systems.
Combined heat and power
At RENCEL, our great experience of energy production facilities based on a variety of fuels is combined with our experience of district heating transmission systems and low-temperature district heating systems. This helps us maximise the environmental, social and economic benefits for both investors and consumers.
We offer our clients all services that are necessary for establishing optimised CHP plants, heat accumulators and district heating systems – from planning, design and procurement to implementation.
Our experience encompasses a wide range of CHP plants, including waste-to-energy, biogas and biomass plants.
Decentralised electric chillers in district cooling systems can often be replaced by less expensive systems that use cold seawater, groundwater or carbon-free thermal energy. Our experience in district cooling includes chilled water storage, district heating absorption heat pumps and decentralized cooling plants based on solar heating.
Heating installations in buildings
The efficiency of a city-wide heating system depends on its integration with low-temperature heating systems in buildings. We provide our clients with expertise in the design and operation of all facilities in the system, including building installations.